Go back to the main prompt and enter the command reboot. Here you can now configure the network settings manually As an example for a system that requires subnet mask 255.255.252.0 the bits would be 22 so the ip address would be enter as 10.218.44.230/22 You can find a subnet mask calculator on line if the bits are not known.

NOTE: When entering the IP address you will need to include the proper subnet mask bits. Select Automatic of the network you need to use and select Manual. On the Edit Connection, there is an option for IPv4 and IPv6 configuration. If the ethernet connection is not known open a terminal window and enter ip addr. Select the Ethernet connection used by PCNS, hit enter or select Edit. It will switch to the Network Manager TUI. Once finished, login as root and enter the command nmtui. PCNS 4.2 Virtual Appliance has switched to a new Operating System, CentOS 7, due to CentOS 5 already being end of life.Īfter deploying the PCNS 4.2 OVA, complete the initial setup and set the root password. PowerChute Network Shutdown 4.2 Virtual Appliance (CentOS 7) PCNS 4.2 Virtual Appliance moved to a new operating system, CentOS 7 NetShelter Metered-by-Outlet with Switching Rack PDU NetShelter Shelving & Mounting Accessories Verify the status of the interface using “if addr” command (the ip address should have disappeared):

Use the ifdown command to stop the interface and eno16777736. The network interface control scripts i.e. Valid_lft forever preferred_lft forever Using network interface control scripts to stop/start a specific network interface If you interface names are somthing like eno16777736, refere this post to change the interface naming to eth0 and eth1. Note that you have 3 Ethernet interfaces (eth0, eth1) and the loopback interface (lo). 1: lo: mtu 65536 qdisc noqueue state UNKNOWN

Centos 7 static ip address setup